multiplexing system

[Guest Close Guest]

Hi,
i'm french i live in alps near Geneva , i bought a LC120 on july (2007) . This europeen model have a multiplexing wiring.
Do u know if Austalian Prado have this multiplexing system.
If yes i would like to know how to cancel the multiplexing on beams, do you use an adaptor for HID bi xenon ?
I have installed HID H4-3 and i have some trouble to control the beams.
The solenoid controler is installed on the right beam.
To prevent ignition and to cancel blue light on dash board i removed the left beam fuse ( on my car i have for the beams one fuse for each side.) But i have an other default: when the engine runs my HID beam are always energized except if the beam level is on position high beam.
Sorry for my poor english, thank u in advance.
Chris

[bitdist Senior Member Find all posts View Profile Close bitdist]

Hi Chris
It may be different here, as I have had no trouble at all putting HID's into the headlights. The right light wiring is just sitting there not connected to anything and the left one is the one driving the HID's and the solienoid box is on the left side. So apart from being the opposite way around to you, it sounds pretty much the same

[Guest Close Guest]

Thank you for your prompt answer
I will try to install the solenoid box on left side.
See u
Chris

[Guest Close Guest]

Hello,
just to say i found a solution to my trouble. I bought a special converter which inactive the multiplex analysis on the car only for the beam.
This converter is installed on bulb orignal connector
thx for help
Chris