I had to pull out my gearbox to replace rear crank main seal and re fitted and my gears don’t work at all. Everything was working fine before I pulled it out. Auto transmission. What am I missing or not doing?
Announcement
Collapse
No announcement yet.
Prado won’t drive after pulling gearbox and re fitting auto transmission
Collapse
X
-
Check trans fluid lines and level.
Check connectors.
Check high low range make sure not in neutral.HKB Electronics, manufacturer of the Alternator Voltage Booster, Silver 2008 D4D,Lifted,Underbody protection, Alternator Voltage Booster, Tiger Z winch, Lightforce DL, Air Horns, Tanami Drawers, Drop down fridge slide, Outback cargo barriers, Rotronics dual Battery system, Polaris GPS, HF/UHF/VHF, Radio speaker combiner, Long ranger water tank, Diff breathers, Inverter, Snorkel and others
-
Did the torque convertor move at all?
If it moved forward and disengaged when the box was pulled back or sitting afterwards while replacing the seal it most likely has not been refitted correctly.
If that is the case you will get no pressure hence no drive.
Lee'18 VX, Billies with Dobinson springs, Summit bar with Narva Enhanced Optics to help my old eyes
Comment
Comment