Announcement

Collapse
No announcement yet.

What did you do to your 150 today?

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • Been to Baileys for injectors etc
    Crystal Pearl Altitude 150 Landcruiser Prado. TJM sensor bar, brush guard, side steps. KM2 BFG on GXL alloys. Kaymar bar, Drifta and MSA fridge slide. ARB locker and compressor, and MK11 compressor and fuel filter bracket.

    Comment


    • Originally posted by steve.armitage View Post
      Fitted AMTS' RJ45 connector into the center console for my UHF radio mic
      That looks good, where did you get it from?

      Comment


      • PP: http://www.pradopoint.com.au/member.php?14108-amts
        FB: https://www.facebook.com/AMTS4x4/

        Comment


        • Prado (2010 Kakadu @ 170k) got a big birthday today - maintenance wise. New injectors and pipes, finally put in my trans cooler (actually two) and I gave the trans a full flush using 12 litres of Penrite LV ATF.

          Even though I got Toyota service to do a full flush a couple of years ago (they only changed 6 litres) the ATF was in a terrible condition. Having the upfront cooler makes for an easy change using spare cooler hose and a couple of temporary barbed hose joiners. I used a small 12v diaphragm pump to push the new ATF back in from the 4 litre ATF container connected to the return line at the cooler and had a separate discharge hose connected to the new radiator discharge hose for the old stuff. Took 4 engine start stop cycles to get everything looking new. Takes about 30 seconds to get out 3 litres using the internal trans pump and took around 5 minutes for the small diaphragm pump to push back the identical amount I took out. The new coolers and hose work add around 1 litre of ATF capacity. If or when I do the flush again, should only take around 30-45minutes next time.

          Touch wood - but engine and trans are working sweet.

          Comment


          • Got plenty done today

            Dual Battery Install
            TowPro Elite
            Anderson plugs
            Fire Extinguisher
            LED Headlights
            Volt/Volt meter

            Click image for larger version

Name:	IMG_1216.jpg
Views:	1
Size:	93.1 KB
ID:	655991
            Click image for larger version

Name:	IMG_1217.jpg
Views:	1
Size:	90.6 KB
ID:	655992
            Click image for larger version

Name:	IMG_1215.jpg
Views:	1
Size:	96.6 KB
ID:	655993
            Click image for larger version

Name:	IMG_1221.jpg
Views:	1
Size:	90.7 KB
ID:	655994
            Click image for larger version

Name:	IMG_1016.jpg
Views:	1
Size:	90.6 KB
ID:	655995

            Comment


            • Originally posted by Starbuck View Post
              Got plenty done today

              Dual Battery Install
              TowPro Elite
              Anderson plugs
              Fire Extinguisher
              LED Headlights
              Volt/Volt meter

              [ATTACH=CONFIG]25313[/ATTACH]
              [ATTACH=CONFIG]25314[/ATTACH]
              [ATTACH=CONFIG]25315[/ATTACH]
              [ATTACH=CONFIG]25316[/ATTACH]
              [ATTACH=CONFIG]25317[/ATTACH]
              Where did you get the led head lights and price
              Update us as what tou think there like compared to std
              Arb colour code deluxe bar, safari snorkel, lightforce venom HID's, GME uhf remote face, redarc tow pro, redarc bcdc 1240, pioneer platform, 40" curved light bar, dual battery, 3" SS exhaust, EGR mod, trans cooler upgrade, provent catch can, scangauge 2, diesel care secondary fuel filter, Tin's bash plates and actuator gaurd, 2in Bilstien and kings lift,

              Comment


              • I got some JW Speaker H11 LED Headlight kit from Autobarn for about $130, very easy to install. You can find them on eBay at the moment for $125 with free postage.

                Compared to the standard globes the LED are so much better. I will change the fog lights too soon with the same as they are also H11 globes

                Comment


                • My 2010 Prado (110k) just got "Anthed" with new injectors, pipes, valve clearance check, compression test and air intake clean.......top job thanks ####!
                  2010 150 Glacier White GXL D4D Auto

                  Comment


                  • I got some JW Speaker H11 LED Headlight kit from Autobarn for about $130, very easy to install. You can find them on eBay at the moment for $125 with free postage.
                    Are these simply a matter of swapping the globes?
                    Are you happy with the result? I'm worried 6200K will be too "blue". Would you consider also doing the high beams (HB3)??
                    Prado 150 D4D AUTO GXL with ARB Deluxe Winchbar, Brains' TG150 Transfer Case Actuator Guard, Bilstein/Ridepro 50mm Lift, Safari Snorkel, D697 265/65/17 LTs, Dual Battery Setup with REDARC Controller, REDARC Tow Pro, Toyota Tow Bar, Maxtrax - towing a Camprite TL8s fitted with GXL wheels and D697s.

                    Comment


                    • Hi Joe, yes very simple as just swapping the globes, all plugs are the same no need for any fancy electrical work. I'm very happy with the results and the colour is bright white. they do also have a 4000K version too.

                      I didn't really consider doing the High Beams as I don't use them very often and quite happy with how they perform, although JW Speaker also make a LED Kit to replace the HB3 Globes.

                      Comment


                      • Thanks, Starbuck - might give 'me a go!
                        Prado 150 D4D AUTO GXL with ARB Deluxe Winchbar, Brains' TG150 Transfer Case Actuator Guard, Bilstein/Ridepro 50mm Lift, Safari Snorkel, D697 265/65/17 LTs, Dual Battery Setup with REDARC Controller, REDARC Tow Pro, Toyota Tow Bar, Maxtrax - towing a Camprite TL8s fitted with GXL wheels and D697s.

                        Comment


                        • Safari Snorkel Fitted

                          Fitted a Safari Snorkel to our 2012 Kakadu today and the hardest part was drilling that first hole and hoping it's in the right Spot 😅
                          Attached Files
                          2012 Pearl White KDJ150R Prado Kakadu
                          ARB Deluxe Bullbar & UVP Plates

                          Comment


                          • Originally posted by jacquesleroux View Post
                            Fitted a Safari Snorkel to our 2012 Kakadu today and the hardest part was drilling that first hole and hoping it's in the right Spot ��
                            You're one of the few owners brave enough to tackle this one themselves, I know I wouldn't

                            Comment


                            • Originally posted by jacquesleroux View Post
                              Fitted a Safari Snorkel to our 2012 Kakadu today and the hardest part was drilling that first hole and hoping it's in the right Spot ��
                              The instructions and template from Safari make the job so easy. Just need a sharp hole saw and a lot of guts. The missus had to walk away when I fitted one a few years ago. Just about to have another go on the new 2.8

                              Comment


                              • Originally posted by Starbuck View Post
                                Got plenty done today

                                Dual Battery Install
                                TowPro Elite
                                Anderson plugs
                                Fire Extinguisher
                                LED Headlights
                                Volt/Volt meter

                                [ATTACH=CONFIG]25313[/ATTACH]
                                [ATTACH=CONFIG]25314[/ATTACH]
                                [ATTACH=CONFIG]25315[/ATTACH]
                                [ATTACH=CONFIG]25316[/ATTACH]
                                [ATTACH=CONFIG]25317[/ATTACH]
                                Hi Starbuck. Re Dual battery install. Is that a 2.8 or 3.0 Prado.
                                If it is a 2.8 what battery tray did you use? and the clamp on top which also ties to the front bar, part of tray kit or separate item? I just got a new 2.8 and I see they have shifted the aircon out of the way which is good. From memory when I did a dual battery in the old 3.0 there were permanent threads in place to bolt the battery tray onto. The 2.8 does not have any threads in place, just holes.

                                Comment

                                canli bahis siteleri bahis siteleri ecebet.net
                                mencisport.com
                                antalya escort
                                tsyd.org deneme bonusu veren siteler
                                deneme bonusu veren siteler
                                gaziantep escort
                                gaziantep escort
                                asyabahis maltcasino olabahis olabahis
                                erotik film izle Rus escort gaziantep rus escort
                                atasehir escort tuzla escort
                                sikis sex hatti
                                en iyi casino siteleri
                                deneme bonusu veren siteler
                                casibom
                                deneme bonusu veren siteler
                                deneme bonusu veren siteler
                                betticket istanbulbahis
                                Working...
                                X