Bought some 4wd supa centre spotties- and am going to mount them on my ARB steel bar( which has three holes on either side of the bar where you would traditionally mount the winch controller)- unfortunately the holes don't line up- only the major hole in the bracket not the other two ( the bracket has 3 holes).
so....has anyone just used the single hole to mount these before and is that stable enough? Or have people drilled out the bracket to match the existing holes in the bullbar?
Or do people just go f$$k it and get a couple tek screws out.....
Any ideas?
Cheers
Smokey
so....has anyone just used the single hole to mount these before and is that stable enough? Or have people drilled out the bracket to match the existing holes in the bullbar?
Or do people just go f$$k it and get a couple tek screws out.....
Any ideas?
Cheers
Smokey
Comment