Announcement

Collapse
No announcement yet.

1KD - P2122 fault code

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • 1KD - P2122 fault code

    Hi

    I've just had some mods done to my 2008 prado. 4" snorkel fitted, custom airbox, stage 3 GTurbo, +30% injectors and a FMIC fitted. Engine started fine but as soon as you start to accelerate the engine light comes on and goes into limp mode (does not even boost up). The code indicates throttle pedal but i swapped this out and the fault re appears.

    P2122 - THROTTLE/PEDAL POSITION
    SENSOR/SWITCH ”D” CIRCUIT LOW INPUT

    Any ideas????

  • #2
    If you have replaced the sensor (with a known good one) and it is the same then a trip to the Dyno is in order bearing in mind the mods you have some remapping might be required. A techstream might be useful as well as checking that you have no leaks from your FMIC

    Comment


    • #3
      Hey Scruffy

      All good. Fault has been found. For some reason a voltage signal from the pedal dropped out. Custom remap and Dyno is booked in and should expect around 170kw at all 4 wheels

      Comment


      • #4
        Look forward to seeing the dyno sheets..

        Comment


        • #5
          Originally posted by shanders View Post
          Hey Scruffy

          All good. Fault has been found. For some reason a voltage signal from the pedal dropped out. Custom remap and Dyno is booked in and should expect around 170kw at all 4 wheels
          Hey Shanders so what was the fix? A second pedal?

          Comment


          • #6
            Auto elec replaced a fried wire between the pedal and ECU. Appears as though the surge protectors the fabricator was using were not protecting. Pays to disconnect the battery!!
            Have tried to attach some pics of the mods
            Attached Files

            Comment


            • #7
              Hi All

              See attached dyno sheet

              156.5kW and 530Nm at wheels in 4WD - 70% power and 58% torque increase. 33" M/T tyres
              Upgrades as follows:
              - S2 GTurbo
              - 30% injectors (1KD)
              - 3" exhaust
              - GTurbo custom ECU tune
              - Front mount intercooler
              Attached Files

              Comment


              • #8
                So it has been a month or two now how is it going? Approximately how much for the work. Did you do anything yourself? I bet there's a smile on your dial.
                Cheers Brian. 2006 Grande D4D

                Comment


                • #9
                  1KD - P2122 fault code

                  Nice setup. Any chance of a bit more info on the 4" snorkel?

                  Comment


                  • #10
                    Hi Brian
                    No issues at all with the car mate. approx. $7k for all the work and mods. As there is not an off the shelf FMIC kit for this model, I did a lot of R&D with the fabricator to get it correct

                    Comment


                    • #11
                      Hi Mick

                      4" powder coated stainless into a custom airbox

                      Comment

                      canli bahis siteleri bahis siteleri ecebet.net
                      mencisport.com
                      antalya escort
                      tsyd.org deneme bonusu veren siteler
                      deneme bonusu veren siteler
                      gaziantep escort
                      gaziantep escort
                      asyabahis maltcasino olabahis olabahis
                      erotik film izle Rus escort gaziantep rus escort
                      atasehir escort tuzla escort
                      sikis sex hatti
                      en iyi casino siteleri
                      deneme bonusu veren siteler
                      casibom
                      deneme bonusu veren siteler
                      deneme bonusu veren siteler
                      betticket istanbulbahis
                      Working...
                      X