I have recently bought a 2005 diesel manual Prado GX and am looking to replace the factory radio with a bluetooth receiver.
The unit that I have landed on for the replacement is a "Pioneer MVH-X395BT Bluetooth Car Stereo".
https://www.ryda.com.au/index.php/pi...FRIEKgodtrAOag
I have also bought a single DIN compartment to go under the new pioneer unit.
https://aerpro.com/fp9016
I had two questions I was hoping someone could advise me on:
1) Are the above two items the only things I need to get a flush finish or is there some other facia bracket of some kind i'll also need to purchase?
2) Will I need a wiring harness of any kind to connect the pioneer unit up?
Would greatly appreciate any info on this... I'm a newby to the forum and Prado world so sorry if any of the above makes no sense.
Cheers!
The unit that I have landed on for the replacement is a "Pioneer MVH-X395BT Bluetooth Car Stereo".
https://www.ryda.com.au/index.php/pi...FRIEKgodtrAOag
I have also bought a single DIN compartment to go under the new pioneer unit.
https://aerpro.com/fp9016
I had two questions I was hoping someone could advise me on:
1) Are the above two items the only things I need to get a flush finish or is there some other facia bracket of some kind i'll also need to purchase?
2) Will I need a wiring harness of any kind to connect the pioneer unit up?
Would greatly appreciate any info on this... I'm a newby to the forum and Prado world so sorry if any of the above makes no sense.
Cheers!
Comment