Results 1 to 2 of 2
  1. #1
    Junior Member jinandrew's Avatar
    Join Date
    Feb 2012
    Location
    Leafy sticks of Eltham, VIC
    Posts
    41

    False Floor Advice

    Looking for some thoughts from others if the following will work?

    Recently I made up a flase floor using 12mm MDF to keep my fridge slide on as the wife loves the fridge, but loves our kids more and still wants to access the rear seating during the week. I was thinking of bolting next to the fridge one of the Drifta Single Kitchen Drawers with table using four flush mounted tie down points. This would create an easy set up and removal as needed.

    My question is do you think there will be any issues with this set up? The floor remains in place with the fridge slide all the way out just wondering if I had fridge slid out and then draw out is that asking too much of the two bolts that are into the back of the seats?

    Any thoughts would be appreciated?

    Thanks,
    Andrew






  2. #2
    HKB Electronics
    Join Date
    Jul 2009
    Location
    Melbourne, VIC
    Posts
    1,543
    Looks very neat Andrew,

    My draw unit uses the existing screw holes in the floor, can't remember what they actually there for but would assume it was to
    mount the rear seats?
    HKB Electronics, manufacturer of the Alternator Voltage Booster, Silver 2008 D4D,Lifted,Underbody protection, Alternator Voltage Booster, Tiger Z winch, Lightforce DL, Air Horns, Tanami Drawers, Drop down fridge slide, Outback cargo barriers, Rotronics dual Battery system, Polaris GPS, HF/UHF/VHF, Radio speaker combiner, Long ranger water tank, Diff breathers, Inverter, Snorkel and others

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •