ARB bar recovery point options?

[Supa Lurker Find all posts View Profile Close Supa]

Hi all, I searched but didn't find anything..
ARB bar fis itted and want to install the recovery points without going via ARB and paying $$$$$
Seems a lot of them will not fit (with various bars)
Anyone fitted these to the 120 with an ARB bar that was not ARB branded and if so, what did you go for?
Thanks!

[Piggy Water pistol pilot. Find all posts View Profile Close Piggy]

Stayed with the standard welded thru factory points. Stronger than a lot of bolt on ones.

[Supa Lurker Find all posts View Profile Close Supa]

Wait I'm confused. are you talking about the welded tie down points?

[Piggy Water pistol pilot. Find all posts View Profile Close Piggy]

Wait I'm confused. are you talking about the welded tie down points?

Yep, Doing the math on the welds they have front and rear, they should be quite capable of around an 8 tonne pull. Use a bridle strap to share the load and it will be fine. The aftermarket hype rated points might be rated on a machine, but not tested on a chassis. I've seen quite a few of them pull out of the chassis during recoveries.