Tweet
Well i’m Stumped. I was installing a battery tray yesterday and because it was so hot I opened all the windows to cool the car down as it was standing outside. I disconnected the battery with the windows down. Connected it all up again to discover that driver window was the only one that would go up. I can’t get the passenger windows to budge. All articles refer to resetting the auto up and down function (5 second down and 5 second up) but none discuss the windows being in the fully down.... Any ideas.....
-
-
DId you try using the switches on the doors? or just the drivers switches? -
I’ve tried both the drivers door and individually each windows controller.... but nothingOriginally posted by Xerotao View PostComment
-
Look in owners manual I had same problem when I disconnected the battery answer is in owners manual about it , from memory was easy fixComment
-
Are you say it won't go up from the passenger window control?HKB Electronics, manufacturer of the Alternator Voltage Booster, Silver 2008 D4D,Lifted,Underbody protection, Alternator Voltage Booster, Tiger Z winch, Lightforce DL, Air Horns, Tanami Drawers, Drop down fridge slide, Outback cargo barriers, Rotronics dual Battery system, Polaris GPS, HF/UHF/VHF, Radio speaker combiner, Long ranger water tank, Diff breathers, Inverter, Snorkel and othersComment
-
gosh...that's a doosey. as LeighW says...you are using the switch on the individual door?
I had the issue a few weeks back, but my windows were up when I disconnected it.
Mine needed do roll down to half way, then up.
I guess worst case, you could pull door skins off and 'hot wire' it to go up, then follow standard process.Comment
-
Not something stupid like youve bumped the rear window lock on from drivers door panel (Not that I think this affects passenger front)Comment
Comment