Install Kenwood 8019s Head Unit

[Mule Member Find all posts View Profile Close Mule]

Have just received new unit from Ryda. I asked for any extra necessary wiring to make it as plug and play as possible with steering controls. Looks a tad more complicated than I was hoping for. Wondering if anyone has experience with fitting a new Kenwood and reverse camera if I get stuck. Hope to get it in on the weekend. I will update if I discover anything of interest to others. Cheers

[Hector_the_dog Junior Member Find all posts View Profile Close Hector_the_dog]

I fitted a new Kenwood unit a few years back. Sorting the wiring for the reversing camera took the most time. The unit fitted easily and I also bought the necessary conversion plug. Depending on the width of the unit you might need the spacers at the side. Mine did but other units are wider. There will also be wires for the auto dimming when lights are on and the reverse switch for the camera. All should be colour coded and not too difficult. Just take care when pulling out the plastic trim etc.

[Mule Member Find all posts View Profile Close Mule]

I fitted a new Kenwood unit a few years back. Sorting the wiring for the reversing camera took the most time. The unit fitted easily and I also bought the necessary conversion plug. Depending on the width of the unit you might need the spacers at the side. Mine did but other units are wider. There will also be wires for the auto dimming when lights are on and the reverse switch for the camera. All should be colour coded and not too difficult. Just take care when pulling out the plastic trim etc.

Thanks, I have purchased side spacers with USB plug and jack, hope it all goes well. I will start with the reverse camera!