Unknown sensor on 150

[Mick Yarra Lurker Find all posts View Profile Close Mick Yarra]

Hi all,
Does anyone know what the sensor is for that is located on the chassis under the vehicle on the left hand. The wires for it come out of a large robber grommet from underneath the LHS passenger seat area and are secured with a black clip then plug into a what plastic sensor that has two small round sensor points thgat are visible and flush with the end of the plastic plug/sensor? Best description i could give sorry.
Cheers,
Micky

[Mick Yarra Lurker Find all posts View Profile Close Mick Yarra]

Typo...a white plastic sensor...

[Mick Yarra Lurker Find all posts View Profile Close Mick Yarra]

Apologies correction...its actually clips in at the rear side on one of the side foot tread support brackets.

[Mike-B Junior Member Find all posts View Profile Close Mike-B]

Its the connection for models with under step lights which turns on when the door is opened.

[Mick Yarra Lurker Find all posts View Profile Close Mick Yarra]

Thanks mate, yes that makes more sense that the end bit is a cap and not a sensor at all! Cheers.

[Mike-B Junior Member Find all posts View Profile Close Mike-B]

Good place to tap into if you want some lights when you open the door. You can run an LED strip if you want.

[Piggy Water pistol pilot. Find all posts View Profile Close Piggy]

Good place to tap into if you want some lights when you open the door. You can run an LED strip if you want.

Often these dont activate unless programmed in the BCM. Seen people connect to them before and they don't work.