ARB have a new kit to mount their CKMP12 twin compressor and air tank behind the left side rear trim on a Prado 150.
Spent the entire Easter break on the install. It's a pig of a job but worth the cuts, bruises and time.
I added extra heat shielding on the polypropylene trim near the compressor, manifold wrap on the air hose from the compressor to the tank, and vent holes around the top of the cup holder vent hot air.
The finished job -
Install pic 1 - pig of a job from back to the front:
Install pic 2 - laying fat cables in door channels and under the carpet:
Install pic 3 - compressor and tank on mounting brackets:
Install pic 4 -, cranking battery, 80A CB on 8mm poly-carbonate sheet clamped on top:
Spent the entire Easter break on the install. It's a pig of a job but worth the cuts, bruises and time.
I added extra heat shielding on the polypropylene trim near the compressor, manifold wrap on the air hose from the compressor to the tank, and vent holes around the top of the cup holder vent hot air.
The finished job -
Install pic 1 - pig of a job from back to the front:
Install pic 2 - laying fat cables in door channels and under the carpet:
Install pic 3 - compressor and tank on mounting brackets:
Install pic 4 -, cranking battery, 80A CB on 8mm poly-carbonate sheet clamped on top:
Comment