Anyone else experiencing this? Mine leans up to 25mm at the rear and 20mm at the front to the drivers side since lifted. The lean may have been there prior to the lift however I never noticed it.
The valves were loosened prior to the suspension being worked on and the reset procedure has been done (rock the car on flat level ground with valves open). I also had Toyota bleed the system to ensure there was no air in there. I have the service manual for the KDSS and it only states these two procedures to correct the system. The lean remains.
Has anyone else experienced this and if so how was it corrected?
The valves were loosened prior to the suspension being worked on and the reset procedure has been done (rock the car on flat level ground with valves open). I also had Toyota bleed the system to ensure there was no air in there. I have the service manual for the KDSS and it only states these two procedures to correct the system. The lean remains.
Has anyone else experienced this and if so how was it corrected?
Comment