Kennys 2014 150 GXL

[Spilsy Avid PP Poster! Find all posts View Profile Close Spilsy]

Anywhere that sells festo pneumatic gear....

https://www.festo.com/cat/en-au_au/products_QS

[P W Junior Member Find all posts View Profile Close P W]

Hi Kenny, Where did they fit the towpro in your GXL?

[foxclan Avid PP Poster! Find all posts View Profile Close foxclan]

The right angle joint of water level gauge of my water tank (one of Tins) got collected by a rock and is cracked, I need one pretty quickly, does anyone know where I can get one in Adelaide?? Had a bit of a look today but no joy!

Hi Kenny
Industrial Fitting Sales, they are on Cormack road Wingfield.
http://www.cylex.com.au/reviews/view...anyId=18456010
Also as Spilsy has suggested Festo suppliers are certain to have them. I think there is a couple of festo suppliers on the Northern end of Churchill road.
Cheers
Troy

[kenny5000 Advanced Member Find all posts View Profile Close kenny5000]

Hi Kenny
Industrial Fitting Sales, they are on Cormack road Wingfield.
http://www.cylex.com.au/reviews/view...anyId=18456010
Also as Spilsy has suggested Festo suppliers are certain to have them. I think there is a couple of festo suppliers on the Northern end of Churchill road.
Cheers
Troy

Cheers Troy, I'll check them out tomorrow!

[kenny5000 Advanced Member Find all posts View Profile Close kenny5000]

Anywhere that sells festo pneumatic gear....

https://www.festo.com/cat/en-au_au/products_QS

Thanks mate, I saw those when searching the internet but unfortunately I don't have time to wait for mail, driving out of Adelaide on Friday.

[kenny5000 Advanced Member Find all posts View Profile Close kenny5000]

Hi Kenny, Where did they fit the towpro in your GXL?

Hi Mate,

The unit is under the dash high inside on the drivers side. the remote is in the centre console in a blank.

Cheers

[P W Junior Member Find all posts View Profile Close P W]

Thanks Kenny, That is where I have looked at mounting the UHF and the TowPro. There is an enormous amount of space in that area, but I could find nothing to mount either item to. Seems such a shame to see all that space go to waste. Thanks for the photo, I was thinking to mount that item on the RHS of the steering wheel.

Cheers, Phil

[kenny5000 Advanced Member Find all posts View Profile Close kenny5000]

Thanks Kenny, That is where I have looked at mounting the UHF and the TowPro. There is an enormous amount of space in that area, but I could find nothing to mount either item to. Seems such a shame to see all that space go to waste. Thanks for the photo, I was thinking to mount that item on the RHS of the steering wheel.

Cheers, Phil

I have a rocker switch to link my batteries there as well as my compressor switch, plenty of blanks to chose from though.

[kenny5000 Advanced Member Find all posts View Profile Close kenny5000]

So I went to remove my right angle fittings from the water gauge to replace them today, when I went to unscrew the fittings I noticed movement in the water tank. Turns out one of the mounts was broken, upon checking the other side it was cracked about 90% through (it broke completely upon removal) so I have had to remove the tank completely until I can fit some new brackets. Im guessing the brakes were caused by my run up to Birdsville a few months ago. For the others who have one of these tanks it would be worth a quick look to make sure yours aren't cracked/broken, hopefully its an isolated occurrence. Pity I didn't notice earlier as I am heading north for 10 days from friday.