Re: A/C Outlet Temp ?
Here's the link to my old fix, for the benefit of anyone coming across this thread in the future.
May be a...
Announcement
Collapse
No announcement yet.
Search Result
Collapse
118 results in 0.0091 seconds.
Keywords
Members
Tags
-
Well done Chippy and Jason, I'll make sure I get one that can do that!
Oh, and from another forum:
"For all those in hot and...
Leave a comment:
-
Good luck with that!
An old fashioned flick switch would be good as well, then you could leave the switch on and wire to accessory as you...
Leave a comment:
-
Easy question Chippy, I was looking at this myself, with a bluetooth reverse camera and gps screen.
When the unit receives power can it...
Leave a comment:
-
Same here, behind the kickpanel, over the door seal, under the little door limiter arm and up. No problems with it, it is visible when the door is open...
Leave a comment:
-
A local fella did it for me, $1500 for a new center, plus $270 labour.
Apparently a rebuilt centre would cost about 1500 too...
Leave a comment:
-
You could carry a steel spare from the wreckers, a bit narrower and easier to cart around.
Just need 6 steel wheel nuts, can be used as an anchor...
Leave a comment:
-
Back on the road again, a bit poorer!
Here's a shot of the blown diff, crown and pinion; kaput.
I am confident Toyota read these...
Leave a comment:
-
Something to think about that.
All the way out after mine blew I was hoping it wouldn't jam up, then I'd be pulling the centre out in deep sand,...
Leave a comment:
-
-
Yes I was going hard, low 2nd and foot to the floor. I had to bash through the sand a bit, the holes were 2 feet deep.
I imagine a wheel bit hard...
Leave a comment:
-
Oh for the record this is where it blew, the crest of a big hill near Kilcarnup.
I turned around at the top and took this...
...
Leave a comment:
-
Woohoo, I'm a member!
Going hard up a sandy hill and the rear diff goes, bummer. Drove it out on the front diff, with a disconcerting clunk/skid/clunk/skid...
Leave a comment:
-
I reckon a well designed one would look sexy too, but if the number of locusts on my intercooler are anything to go by the double skin bonnet works pretty...
Leave a comment:
-
Thanks for the replies guys. I am getting really close to actually doing something about repairing it!
Popped off the little triangle inside...
Leave a comment:
Leave a comment: