Installation of Pioneer MVH-X395BT unit in 2005 GX prado

[Ferdirl Lurker Find all posts View Profile Close Ferdirl]

I have recently bought a 2005 diesel manual Prado GX and am looking to replace the factory radio with a bluetooth receiver.

The unit that I have landed on for the replacement is a "Pioneer MVH-X395BT Bluetooth Car Stereo".

https://www.ryda.com.au/index.php/pi...FRIEKgodtrAOag

I have also bought a single DIN compartment to go under the new pioneer unit.

https://aerpro.com/fp9016

I had two questions I was hoping someone could advise me on:

1) Are the above two items the only things I need to get a flush finish or is there some other facia bracket of some kind i'll also need to purchase?

2) Will I need a wiring harness of any kind to connect the pioneer unit up?

Would greatly appreciate any info on this... I'm a newby to the forum and Prado world so sorry if any of the above makes no sense.

Cheers!

[Mozz Member Find all posts View Profile Close Mozz]

That is all you need to mount the unit mate. If you buy the harness it is a simple plug in job, otherwise you just need to cut the original loom and slider in the Pioneer one not hard.