remooving middle row seats

[404pug Avid PP Poster! Find all posts View Profile Close 404pug]

Had a search but couldn't find any tips for getting the plastic covers off the mounting bolts for the middle row of seats. Any tips to avoid breaking them ? Neil

[ozwapet2 Advanced Member Find all posts View Profile Close ozwapet2]

Re: remooving middle row seats

I have removed my centre row seats for a long trip on a previous occassion.
If I remember correctly, removing the cover requires a large screwdriver inserted from the rear and at the bottom on either side, release the clips with an outward movement, then slide the whole cover backward.
I haven't replaced my covers as I am probably going to take the seats out again, so will try to take a pic of one.

( and regards from a fellow Pug owner -307 not a classic )

[404pug Avid PP Poster! Find all posts View Profile Close 404pug]

Re: remooving middle row seats

Ta - the 404 has been replaced with a 504 I owned for 14 years and then bought back after another 17! In great condition. Neil

[Guest Close Guest]

Re: remooving middle row seats

Here is the thread
viewtopic.php?f=2&t=6390&p=89919

[404pug Avid PP Poster! Find all posts View Profile Close 404pug]

Re: remooving middle row seats

Ta for that. I like the flat floor area.

[nickchap Member Find all posts View Profile Close nickchap]

Re: remooving middle row seats

404pug

When you get the seats out(unclip and slide) I used existing holes to put flat floor in.
It is a bit of bending but used the front seat bolts to secure the base.

Then removed the rear step inside the door to secure the rear of the frame.

Also included a strip in the floor for ratchet tie downs.



Have fun

Nick