Acceptable rotor thickness and run-out specs?

[prh Member Find all posts View Profile Close prh]

Can someone advise the acceptable minimum rotor thickness and maximum run-out for front and rear disk rotors?

Thanks!

Paul

[LargeInAPrado Member Find all posts View Profile Close LargeInAPrado]

Re: Acceptable rotor thickness and run-out specs?

there shouldnt be any runout ...but 0.002 is probably max acceptable before we start to get to machine or scrap

When measuring the runout also measure the mounting hub as ive measured some serious runout in the actual bearing hub

Prado 120 front and rear rotor specs
part # Type , OD, ht , max, min, ctr, studs,
DR793 Rear Vented , 312, 68, 18, 16, 106, 6, 9/02 on Rotor GRJ, KDJ, KZJ, LJ, RZJ, TRJ12# Series
DR2700 Front Vented , 338, 68, 28, 26, 108, 6, 9/02 on Rotor GRJ, KDJ, KZJ, LJ, RZJ, TRJ12# Series

[prh Member Find all posts View Profile Close prh]

Re: Acceptable rotor thickness and run-out specs?

Thanks, that's the information I needed!

Paul