Multiple Spot Lights Wiring Diagram

[MattyB1972 Lurker Find all posts View Profile Close MattyB1972]

Hi Guys,
Ive googled and searched for a wiring diagram for the below configuration however, too many images showing just one pair of spots or multiple spots with one switch.

I want to have three separate switches for the following- spot lights (On Bullbar), LED Light Bar (Mounted on roof rack, forward facing) and two smaller LED Light Bars (mounted on the rear of the roof rack).

I am currently installing the Ironman 140amp duel battery kit and have ripped out all of my and the previous owners wiring with expectations to install everything off the secondary bat, now im just looking for a tidier wiring diagram.

Thanks in advance and apologies for asking this question again as I know that it surely must have been asked many times over the years...

[Guest Close Guest]

you would simply use the same setup as a single spot setup.. and add more.
Take the Hi beam feed and feed it to a switch that controls a relay (Bullbar spots) Copy this exact thing from a second switch also fed by Hi Beam, (Roof lights). The rear lights should be fed from a reverse light feed (If desired) or permanent/IGN power which then through a switch feeds a relay to the rear spots.
Myself I would want a way to have rear spots come on in reverse, but can be switched off if desired, and also the ability to control them manually. (This will need a single 3 position switch or 2 switches).

Not in a position to do a diagram currently but its very straightforward.

[MattyB1972 Lurker Find all posts View Profile Close MattyB1972]

Thanks piggy, i understand what your saying. Dont trouble yourself with a drawing un less some one else wants it?

[Guest Close Guest]

I would add that a trailer wiring loom is recommended to take the signal wires through the firewall. Get a 7-core loom for future expansion. So you will only need to punch through the firewall grommet once instead of multiple times.