Fog light symbol on dash

[JGD Member Find all posts View Profile Close JGD]

they are all lit by small LED's soldered to the circuit board.
my fog light indicator will never work, cos there is no LED soldered in for this. bugger.
so for those trucks that the foglight indicator doesn't light up.
yer probably in the same boat.
1 good thing. LED's rarely blow, so i don't have to worry about removing it to fix a blown globe.

Thanks damonat - unbelieveable work! How long did it take to remove the cluster??

So that then begs the question, if there is no LED installed in some clusters, does the printed curcuit board permit a LED to be installed? Or is it not possible to get to the front of the board to even see if this is possible?

I wonder when the LED for the symbol became standard? Judging by those that have posted here, it must have been from late 2004 onwards - Bugger!

[MickL Addicted PP Member Find all posts View Profile Close MickL]

I wonder when the LED for the symbol became standard? Judging by those that have posted here, it must have been from late 2004 onwards - Bugger

Mine has one, Dec 05 build.

Mick.

[damonat Advanced Member Find all posts View Profile Close damonat]

took 40 minutes in and out. easy job.
you could fit/solder LED's to the board, just hard to do and the facia would need to be removed, but do-able.
very small led's, about 2mm square in size

[adamrick Lurker Find all posts View Profile Close adamrick]

Damonat,

I have taken your first pic and circled in red what I think might be the rear fog switch connector (wrapped up with another harness). If you unwrap the black tape, you may find the rear fog lamp connector there....

[damonat Advanced Member Find all posts View Profile Close damonat]

Re: Fog light symbol on dash

Aithough I can't remember.. I think if ya blow a bulb on the front fog lamps, the symbols doesn't show green.... is this right :?: :?: :?: :?:

i don't believe so.
the LED would be wired in in parrellel, not series