I have installed my dual battery system about two weeks ago now, other than that (and it's been running fine) I have not changed anything.
This morning, my indicator fuse blew, so I stopped at a servo, threw in the spare 15AMP and tried again, left works, right, blows fuse again, and again.....
Went through 4 x 15AMP fuses, ended up putting in a 20AMP, I know this is not right, but they work, and had to go to work today, otherwise I'd of stayed home and investigated.
This happened to me once before, before I did ANY changes.
Any ideas where to start looking? I am hoping I do not have to pull out the second battery, but I am thinking the look that runs down the bottom, passed the bottom of the tray may be rubbing on the tray bolts. Another thought was the lights for the Sov bar have shorted somewhere. Is there a common place I can look?
Advice greatly appreciated.
Mark.
This morning, my indicator fuse blew, so I stopped at a servo, threw in the spare 15AMP and tried again, left works, right, blows fuse again, and again.....
Went through 4 x 15AMP fuses, ended up putting in a 20AMP, I know this is not right, but they work, and had to go to work today, otherwise I'd of stayed home and investigated.
This happened to me once before, before I did ANY changes.
Any ideas where to start looking? I am hoping I do not have to pull out the second battery, but I am thinking the look that runs down the bottom, passed the bottom of the tray may be rubbing on the tray bolts. Another thought was the lights for the Sov bar have shorted somewhere. Is there a common place I can look?
Advice greatly appreciated.
Mark.
Comment