Announcement

Collapse
No announcement yet.

A/C Fan not working

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • A/C Fan not working

    I am after some advice regarding the A/C fan controls. Overnight the 2 lower fan speeds have stopped working only leaving the 3rd and 4th settings available. Does anyone have any thoughts as to what may have gone wrong. I am not sure if it is electrical or perhaps some form of linkages/connections in the unit. thanks

  • #2
    Re: A/C Fan not working

    Faulty fan switch, wire broken off etc. Most likely the issue.

    Comment


    • #3
      Re: A/C Fan not working

      Originally posted by troyfamily
      I am after some advice regarding the A/C fan controls. Overnight the 2 lower fan speeds have stopped working only leaving the 3rd and 4th settings available. Does anyone have any thoughts as to what may have gone wrong. I am not sure if it is electrical or perhaps some form of linkages/connections in the unit. thanks
      Hi Troyfamily,
      If the blower motor works at any fan speed then depending on your Vehicle Model and A/C system Auto/Manual if a manual system it is most likley the Blower resistor which is located in the A/C plenum if it is an AUTO AC system then it could be the motor speed controller or AC ECU or as Team Piggy has explained a loose connector/ wire.
      I have had a few blower resistor failures but they have been easy to access in previous vehicles, the manual has the blower resistor/ motor speed control (depending which type fitted to your vehicle) located adjacent and under the blower motor housing but it looks like a fair bit of work to access and remove the blower assy located behind your glove compartment removal of the resistor or controller is simple enough. .
      07 Upgrade GXL D4D, Manual, Dune,Sov Bar, BFG's, SG11, Redark dual Batts, Extensive Aux wiring, Stebel, LED stop tails, IPF HID's (my mod), 240V Inv, ARB Comp, GME UHF,TPMS, Safari snorkel, GPS,Hilux washers, 40l Engel in 30% pas pos,homemade A/C cond protection plate, polyairs.

      Comment


      • #4
        Re: A/C Fan not working

        If it's a GXL with manual aircon (Not climate control) then the dropping resistor for the fan/blower motor is attached to the outside of the blower fan housing. Passenger side, front, under the cabin filter. Not to hard to get at. Easy to test with a multi meter.


        Mick
        [CENTER][B][I][SIZE=1][COLOR=blue]1KZ-TE Turbo Diesel, 5 speed manual, 3.5 inch lift, 265/70/17 Mickey Thompson MTZ, D-Tronic chip, Boost controller, mandrel exhaust, dump pipe, modified intake, ARB steel bar, Magnum winch, Safari snorkel, rear drawers, half cargo barrier, dual batteries, Uniden UHF, Sat Nav, reverse camera, Magellan XL , Tjm bash plates, ARB alloy roof rack, rear telescopic work light and numerous other modifications!!!
        Now with 3BAR MAP sensor & 18PSI Boost![/COLOR][/SIZE][/I][/B][/CENTER]

        Comment


        • #5
          Re: A/C Fan not working

          SENSATIONAL..... thanks boys for your replies

          Comment

          canli bahis siteleri bahis siteleri ecebet.net
          mencisport.com
          antalya escort
          tsyd.org deneme bonusu veren siteler
          deneme bonusu veren siteler
          gaziantep escort
          gaziantep escort
          asyabahis maltcasino olabahis olabahis
          erotik film izle Rus escort gaziantep rus escort
          atasehir escort tuzla escort
          sikis sex hatti
          en iyi casino siteleri
          deneme bonusu veren siteler
          casibom
          deneme bonusu veren siteler
          deneme bonusu veren siteler
          betticket istanbulbahis
          Working...
          X