Announcement
Collapse
No announcement yet.
Suspension Database
Collapse
This is a sticky topic.
X
X
-
Originally posted by Whitey View PostSome more book keeping for the database. The advertised lengths of 420-563mm for the Koni RAID 88-1712 are not correct. I measure 431-548mm ring eye centre to shaft flange where first bush washer sits. I've also had a dealer in another city double check and they verify same measurements.
The real open length of the 88-1712 is very short at 548mm, and will give minimal droop in lifted Prados...
Ok I have a list of Measurements.
- Body OD 55mm
- Spring Seat to center of low eye 215mm
- Full Compressed 430mm
- Full Extended 563mm
- Piston rod 16mm
- Top of Body to the center of low eye 215mm
KONI 88-1712SP2
Cheers
Frank
Comment
-
Just wondering if you had specs for the Tough Dog FC41118 (150 series) vs FC41111 (80/105 series)?2012 150 Altitude 4.0L V6 - ARB deluxe winch bar, Old Man Emu 2" suspension lift, FJ Cruiser wheels (17 x 7.5J ET15), Toyo AT2 LT245/75R17, Safari Snorkel, K & N air filter (33-2438), ERPS 6-coupler, Toyota towbar (2500kgs), ARB front rated recovery points (8000kgs), Bushranger recovery hitch + 4.75T shackle (WLL 5000kgs), ARB under vehicle protection, Brains actuator/transfer case guard, GME TX670, GME 3550s, Kaymar rear bar
Comment
-
Can the database be updated with the following front coils?
Front Coil Free length (mm) Spring rate (lb/in)
KHFR-168 355mm 660Lb/in
KHFR-168H 365mm 660Lb/in
KHFR-168T 365mm 580/660Lb/in ( progressive rate )
KHFR-168HT 375mm 580/660Lb/in ( progressive rate )
The KHFR-168 has replaced the KTFS-101 effectively.
The 168 series fills gaps in available options for the Prado 120 ( and others )
Also the KH-FR168H give you another option between
King KTFR-101 /101H in terms of free lenght to fine tune the height you end up with.
Personally, I'm fitting the KHFR-168HT to my V6 Grande with new TEMS shocks after winch/bar/plates - which added ~95kg.
Comment
Comment