Bushskinz UNderbody Protection - Installation advice needed.

[fido666 Banned Find all posts View Profile Close fido666]

Some time back I purchased a set of Bushskinz bash plates for my 150 Kakadu. I finally got around to trying to install them yesterday as the old bent Ironman plates had been removed for servicing. Upon unwrapping them I discovered some bags of bots and spacers but no instructions.

Can anyone who has installed them on a 150 series help out with some pointers? I have Googled to no avail, can't even find a clear picture. This one is off his Facebook page but doesn't show me much.



It gives me a few clues but not the order of installation of the 3 plates and exactly which bolts go where.

[fido666 Banned Find all posts View Profile Close fido666]

OK, we have managed to install the first two plates (front and sump). We still have the transmission guard to go but I have left it off to do some additional cleaning underneath. I will put up some pics and notes later, they might help someone else.

[Apples_88 Lurker Find all posts View Profile Close Apples_88]

Hey Mate looks good so far, interested to see the end result with the Trans guard in place.

[fido666 Banned Find all posts View Profile Close fido666]

Have not installed it yet, will put up pics when I do. I also have a set of PDF installation instructions that Kieron from Bushskinz sent to me, PM me with your email address if you want them.

[Russ55 Lurker Find all posts View Profile Close Russ55]

Hey fido666
I'd love a copy of those instructions. I've asked bushskinz but had no reply.
Cheers

[malloc Member Find all posts View Profile Close malloc]

I've just ordered a set to replace my bent factory ones.

Keen to see photos when you have them, especially how they mate up with your t13 bar.

[photoprado Avid PP Poster! Find all posts View Profile Close photoprado]

I have the 150 install file, but it is too large (9.3mb) to post here on PP

Try this download:

https://ufile.io/p1d8q

Live for 30 days

[Russ55 Lurker Find all posts View Profile Close Russ55]

Thanks Cobber- appreciated.

[malloc Member Find all posts View Profile Close malloc]

I have the 150 install file, but it is too large (9.3mb) to post here on PP

Try this download:

https://ufile.io/p1d8q

Live for 30 days

Thanks, installed mine on the weekend following these instructions. Pretty straightforward, took <30mins.

Photos here: http://www.pradopoint.com.au/showthr...l=1#post572947