Remove bull bar back to standard bumper

[therang Lurker Find all posts View Profile Close therang]

Hi all,
New to the prado scene. Picked up a petrol 2010 kakadu and so far loving it. Our style of driving doesn't require us to have a bullbar so we're looking at getting rid of the factory alloy bar and replacing it with the standard kakadu front bar.
Had a bit of a look around but unsure as to where to pick one up from?
Could anyone point me in the right direction at all?
Thanks, Luke

[mjrandom Out of control poster! Find all posts View Profile Close mjrandom]

It will be hard because most bars use a bumper cut so no complete bumpers are discarded. The only exception that I know of is the AFN bar. Could be worth going through this thread

http://www.pradopoint.com/showthread...gallery/page16

And see if anyone still has the front factory bar.

[Guest Close Guest]

The 2010 isn't the facelift model. So there won't be full bumpers because AFN only do bullbars for the facelift model.

[mjrandom Out of control poster! Find all posts View Profile Close mjrandom]

Good point.

[Gasmanjc Junior Member Find all posts View Profile Close Gasmanjc]

I was hoping to keep some parts off my front bar, TJM cut straight through the headlight washers even after I had asked them to keep all the bits intact. All i ended up with was the fog lights and the lower grille.

[therang Lurker Find all posts View Profile Close therang]

bugger, might just give up on this one i think

[fido666 Banned Find all posts View Profile Close fido666]

I was hoping to keep some parts off my front bar, TJM cut straight through the headlight washers even after I had asked them to keep all the bits intact. All i ended up with was the fog lights and the lower grille.

What? My TJM bar has the headlight washers off the original bar installed.