Replacing Sill Plastic Covers after Routing Cables down LHS Sill

[hulbyw Senior Member Find all posts View Profile Close hulbyw]

Have just fitted a brake controller and ran power cables for the controller and rear power sockets down the LHS sill. Problem now is the sill covers are fouling on the split tube that I used to protect the cables, and don't wan't to clip down into place. Have others overcome this problem by shaving the bottom off the plastic legs under the sill covers or do you just leave the cables uncovered so the sills will fit back?
Cheers.......Wayne

[maxjj Senior Member Find all posts View Profile Close maxjj]

mine was a bit of a tight fit after fitting power cables and brake controller, so I took a bit off the little plastic legs.

[hulbyw Senior Member Find all posts View Profile Close hulbyw]

Thanks maxjj. Might do a little trimming tomorrow