Redarc Gauge Install

[bernstar Lurker Find all posts View Profile Close bernstar]

Does anyone know the best place to pick up 'Park Light Positive' and 'Dash Light Negative' from under the dash to light up a redarc dual voltage gauge.

[Leethal Advanced Member Find all posts View Profile Close Leethal]

Not exactly sure however what your looking for sounds like a complicated way of looking for dash illumination.
From memory Green is the dash illumination positive and go to ground for your negative.

Lee

[bernstar Lurker Find all posts View Profile Close bernstar]

Not exactly sure however what your looking for sounds like a complicated way of looking for dash illumination.
From memory Green is the dash illumination positive and go to ground for your negative.

Lee

Yeah its a bit confusing but thats whats in the instructions, just have to try and see what happens, thanks Lee

[Leethal Advanced Member Find all posts View Profile Close Leethal]

To confirm it is for the gauge illumination just connect the two wires from the gauge concerned to a 12V battery, if it lights up then all good. I am assuming it has minimal draw (LED) if so it should be fine on the dash circuit although I am no expert.

Lee