Tweet
I am trying to feed wire to Anderson plug on a tow bar through left rear area. There is a blank grommet which is shown on the picture. Does anyone know how to push it through into a cabin? 
-
-
Just push it.
-
It is not clear where it should go. Inside a hole there is black plastic with traces of fixing foam. On the left side there is another grommet entry into the cabin but it is used already by some othe wiring. Inside the cabin directly above that grommet hole there is a promising entry hole without a grommet. But as I said I could find a way to push a wire directly up as it is blocked by black plastic plate. Are any suggestions please?Comment
-
I had trouble finding a way through the grommets too. I'm not sure if this helps but I ran the Anderson cables through the driver's side door sills, over the rear wheel arch and through the load space floor, also on the driver's side. I used a hole saw to cut the holes and added rubber grommets to protect the cables fromthe metal's edges.
Comment
-
Thank you GeeWhizz, I have my electric hub on a left side of the drawers at the back. This is the prefered position for me to get the wiring from.Comment
-
Are there any blanket grommets/holes inside of cabin at the rear? I can not see anything obvious and hate to start removing drawersComment
-
Few blanket gromments are in a middle of floor - as discussed in another thread: https://www.pradopoint.com.au/forum/...om-2nd-battery
I wonder if there any spare ones at the right or left?Attached FilesComment
-
-
Just cut and extend the hole through which the wires go in your first photo then fill in with silicone. Just check it out from underneath firstComment
-
Thanks 404pug, I removed drawers yesterday and I could see 60 mm blind grommet on a right side in a cabin and there are two 50 mm immediately beneath on a frame rail. I used those holes to wire through.Comment
Comment