Hi everyone,
I recently read a very useful thread on here about setting up an extra PID to measure DPF% in Toreque Pro. The member suggest using PID 2138 with equation J*2.
The post can be viewed here
However, when I look at the menu used for adding extra PID in torque pro, there are actually quite a few data fields. Could anyway please confirm if I have entered the data in correctly?:
OBD2 Mode and PID: 2138
Long name: DPF Blackage %
Short name: DPF%
Minimum value: 0
Maximum value: 100
Scale factor: x1
Unit Type: [blank]
Equation: J*2
OBID Header to use: [Blank]
Diagnostic Start Command: [blank]
Diagnostic stop command [Blank]
Overides PID: Dose not overide any PID
So the only info that I filled in were the 2138 and the Equation (in red)
Have I done the right thing?
Thanks
I recently read a very useful thread on here about setting up an extra PID to measure DPF% in Toreque Pro. The member suggest using PID 2138 with equation J*2.
The post can be viewed here
However, when I look at the menu used for adding extra PID in torque pro, there are actually quite a few data fields. Could anyway please confirm if I have entered the data in correctly?:
OBD2 Mode and PID: 2138
Long name: DPF Blackage %
Short name: DPF%
Minimum value: 0
Maximum value: 100
Scale factor: x1
Unit Type: [blank]
Equation: J*2
OBID Header to use: [Blank]
Diagnostic Start Command: [blank]
Diagnostic stop command [Blank]
Overides PID: Dose not overide any PID
So the only info that I filled in were the 2138 and the Equation (in red)
Have I done the right thing?
Thanks
Comment