150 Transfer Case and Actuator Guard

[fatty boy Member Find all posts View Profile Close fatty boy]

Hi Tin,

Is it compatible with ARB UVP and long range tank in my swb?

[Tin175 Senior Member Find all posts View Profile Close Tin175]

Hi Tin,

Is it compatible with ARB UVP and long range tank in my swb?

I have fitted one to a wagon with ARB UVP. Not sure about the long range tank on the swb. Where does the long range tank sit? In front of the rear diff or behind?

[Spills Lurker Find all posts View Profile Close Spills]

I'll also take one when you do a run!!!

[kenny5000 Advanced Member Find all posts View Profile Close kenny5000]

Hey Tin, do you have any left to suit ARB UVP?

[toddles79 Lurker Find all posts View Profile Close toddles79]

Just finished installing some Ironman underbody on my 150 this weekend, did engine, trans and fuel tank. There is still a big gap between the tank guard and the trans guard, even with the trans guard extending about 200mm behind the cross member. I am keen to see if your guard will fit Tin and I am in Brisbane. Might need to trim the trans guard, or bracket them together...

[Tin175 Senior Member Find all posts View Profile Close Tin175]

Hey Tin, do you have any left to suit ARB UVP?

Yes, I still have a couple.

[Tin175 Senior Member Find all posts View Profile Close Tin175]

Just finished installing some Ironman underbody on my 150 this weekend, did engine, trans and fuel tank. There is still a big gap between the tank guard and the trans guard, even with the trans guard extending about 200mm behind the cross member. I am keen to see if your guard will fit Tin and I am in Brisbane. Might need to trim the trans guard, or bracket them together...

Happy for you to come around and have a look or test fit. I'd be keen to have a look at the fuel tank guard as I am thinking of doing a guard for mine.

[toddles79 Lurker Find all posts View Profile Close toddles79]

Thanks Tin, PM sent. Will take some photos and post up for everyone.

[virgen1 Lurker Find all posts View Profile Close virgen1]

Pradoprime,
Interested in purchasing together to save freight?

SOL.

hi Sol

have you guys ordered yours yet I might be interested as well if that is ok to save freight

thanks

Tony

[virgen1 Lurker Find all posts View Profile Close virgen1]

hi Tin

would this be compatible with the brown davis under body protection?

thanks

Tony

[kenny5000 Advanced Member Find all posts View Profile Close kenny5000]

Yes, I still have a couple.

I might grab one in a few weeks after the silly season!!

[pradoprime Junior Member Find all posts View Profile Close pradoprime]

I haven't, I'm going to have to put mine off till mid next year, what with Christmas and a 3month trip over to the west and back.

[Tin175 Senior Member Find all posts View Profile Close Tin175]

hi Tin

would this be compatible with the brown davis under body protection?

thanks

Tony

Hi Tony,

The BD plates seem to have a folded up lip behind the cross member. I think it would foul but would only require some small cutouts to make it fit.

[Arien Member Find all posts View Profile Close Arien]

hi Tin,

any plans for the 150 V6 ?

[Tin175 Senior Member Find all posts View Profile Close Tin175]

hi Tin,

any plans for the 150 V6 ?

The exhaust on the V6 is a problem. Hangs down quite low behind the cross member which makes it hard for me to find sufficient mounting points.