Sorry for the delayed response.
We were measuring on the mechanics floor which is as level as it's going to get. Also it was where it was measured pre-lift.
So just so I'm getting this correct:
Install the springs, if I can get an increased I should install a 6mm strut spacer front right corner only? Then bleed the KDSS system after the install of the new shocks and springs?
If it still has a lean will a spring spacer make a difference?
I have bull bar, winch, dual battery, under vehicle protection, rock sliders and roof rack.
What spring rate can you guys recommend?
We were measuring on the mechanics floor which is as level as it's going to get. Also it was where it was measured pre-lift.
So just so I'm getting this correct:
Install the springs, if I can get an increased I should install a 6mm strut spacer front right corner only? Then bleed the KDSS system after the install of the new shocks and springs?
If it still has a lean will a spring spacer make a difference?
I have bull bar, winch, dual battery, under vehicle protection, rock sliders and roof rack.
What spring rate can you guys recommend?
Comment