I was trying to flush out the coolant from my Prado yesterday. From reading, the old coolant has to be flushed out completely including the one in heater core and engine.
According to Haynes Manual, the engine coolant drain is located on driver's side. However when I looked at my engine it's different. The bolt is there, but there is no "spout" nor holes. Furthermore the location is so difficult to reach and there is no way I can undo the bolt without removing the power steering pump and AC compressor ...
Am I looking at the right location, or is there any other drain location which I could use?
According to Haynes Manual, the engine coolant drain is located on driver's side. However when I looked at my engine it's different. The bolt is there, but there is no "spout" nor holes. Furthermore the location is so difficult to reach and there is no way I can undo the bolt without removing the power steering pump and AC compressor ...
Am I looking at the right location, or is there any other drain location which I could use?
Comment