150 GXL Bilstein/King Suspension and Genuine Steps/Roof Rails/Skid Plates

[rwo Advanced Member Find all posts View Profile Close rwo]

ITEM: Prado 150 GXL Genuine Side Steps
CONDITION: Used about 10000kms then removed, a few cosmetic scrapes on the rear/side of each step, aluminium frame and mounting brackets un-damaged.
REASON FOR SELLING: Replaced with ARB steps.
PRICE AND PRICE CONDITIONS: $200
EXTRA INFO: Does not come with any mounting bolts (12 x M10x25mm I believe but can pull one out to check if required).
LOCATION: Boddington, WA
PICTURES:
http://s30.postimg.org/lynojun8x/Driver_Scrape.jpg
http://s30.postimg.org/k8nj88soh/Passenger_Scrape.jpg
http://s28.postimg.org/8jf1hilul/Top.jpg
http://s28.postimg.org/tp8uc3wnx/Underside.jpg


ITEM: Prado 150 GXL Genuine Roof Rails
CONDITION: Used, about 8000kms then removed. Been wrapped in plastic since they were taken off so as good as new.
REASON FOR SELLING: Replaced with Rhino Platform legs and I'm sick of moving them around the garage.
PRICE AND PRICE CONDITIONS: $200
EXTRA INFO: Comes with all mounting bolts and brackets etc.
LOCATION: Boddington, WA
PICTURES: They come with everything as per the picture below (shamelessly stolen from maulbeagle's post) but happy to un-wrap if you want to have a look.
http://s25.postimg.org/q4bwfsk4f/rails.jpg

ITEM: Prado 150 GXL Genuine Skid Plates
CONDITION: Used, about 3000kms then removed. No dents or deformity, just a couple of small scratches.
REASON FOR SELLING: Replaced with BD plates
PRICE AND PRICE CONDITIONS: $50
EXTRA INFO: Comes with engine plates and the little bit of tin that goes over the transfer case
LOCATION: Boddington, WA
PICTURES:
http://s27.postimg.org/x99pjx7eb/IMG_3683.jpg
http://s29.postimg.org/sndhuqfrb/IMG_3684.jpg

ITEM: Tekonsha P3 Brake Controller
CONDITION: Installed in vehicle, used a few times then we sold the trailer and haven't replaced it, unit has been wrapped in bubble wrap since...
REASON FOR SELLING: Don't have anything to tow
PRICE AND PRICE CONDITIONS: $100
EXTRA INFO: Comes with the box, mounting brackets and brand new wiring harness (I purchased a spare some time ago and never needed it). For an extra $20 I will supply a replacement driver side lower trim panel for the 150 with the bracket mounted on the LHS. I have replaced mine with an undrilled one and this will save you drilling holes in yours to mount the bracket.
LOCATION: Boddington, WA
PICTURES:
http://s17.postimg.org/pker721db/IMG_3667.jpg
http://s22.postimg.org/xhqc0dhvl/IMG_3670.jpg
http://s29.postimg.org/qvo7atnwn/IMG_3673.jpg


ITEM: Stanadyne FM100 31865 Filter
CONDITION: New, unused
REASON FOR SELLING: came with my filter kit but I replaced it with the short filter and never used this one
PRICE AND PRICE CONDITIONS: $20
EXTRA INFO: It's a fuel filter...
LOCATION: Boddington, WA
PICTURES:
http://s29.postimg.org/5ei00l2yv/IMG_3674.jpg

All items are pickup only from Boddington, WA (about an hour SE from Armadale along Albany Hwy).

[Yokomo Lurker Find all posts View Profile Close Yokomo]

Would these shocks fit a 120?

[jayden82 Junior Member Find all posts View Profile Close jayden82]

Hi RWO, how high is the lift with your shocks and springs?
Cheers

[raydes Advanced Member Find all posts View Profile Close raydes]

Would these shocks fit a 120?

yes ,,they have the same part #

[rwo Advanced Member Find all posts View Profile Close rwo]

Was sitting at 795mm front and 835mm rear (with airbags).