Issues after replace clock spring

[rafaels13 Lurker Find all posts View Profile Close rafaels13]

Hello guys, I need some help.
My car horn, was failing, the fuse, relay and horn was fine. Finally I detected that the problem was the clock spring.
Then after replace the clock spring the horn is working fine but my dashboard It lighted up with 2 icons (slip indicator and Electronic Power Steering warning), I used a car code reader and I got a error "C1433 steering angle sensor internal circuit".
After read a lots of articles in internet all says that is needed recalibrate the SAS (steering angle sensor). I donīt want to spend a lots of money in the the car agency.
Any one have idea if this procedure using the diagnostic wires is safe and work with my prado 150 series http://alflash.com.ua/tsb/ZERO%20POI...ALIBRATION.pdf
Or if any one can share with me other ideas about how I can fix this.

Thanks in advance.

[Graydog Find all posts View Profile Close Graydog]

Sorry Rafaels. Maybe a bit late for you but maybe a help for others.
When mine failed a couple of years ago I just rewired the horn direct to a push button on the dash via battery and external fuse.
About $30 and perfectly legal.
Cost of a clockspring and time for replacement just prohibitive for an older car.

[rafaels13 Lurker Find all posts View Profile Close rafaels13]

Thanks you Graydog for your comments, Unfortunately I cant try your solution.

[Guest Close Guest]

Did you happen to rotate the steering column while you were performing the replacement?

[rafaels13 Lurker Find all posts View Profile Close rafaels13]

Did you happen to rotate the steering column while you were performing the replacement?

Hi Amts, well I just remove the steering wheel components including the airbag until get free the clock spring to be replaced. I Never moved the steering wheel.

[palmers_101 Lurker Find all posts View Profile Close palmers_101]

Hi,

did you you find a solution?

[Smiddi Lurker Find all posts View Profile Close Smiddi]

After removing the steering wheel to slightly adjust angle I seem to have the same issue...