Looking for some thoughts from others if the following will work?
Recently I made up a flase floor using 12mm MDF to keep my fridge slide on as the wife loves the fridge, but loves our kids more and still wants to access the rear seating during the week. I was thinking of bolting next to the fridge one of the Drifta Single Kitchen Drawers with table using four flush mounted tie down points. This would create an easy set up and removal as needed.
My question is do you think there will be any issues with this set up? The floor remains in place with the fridge slide all the way out just wondering if I had fridge slid out and then draw out is that asking too much of the two bolts that are into the back of the seats?
Any thoughts would be appreciated?
Thanks,
Andrew
Recently I made up a flase floor using 12mm MDF to keep my fridge slide on as the wife loves the fridge, but loves our kids more and still wants to access the rear seating during the week. I was thinking of bolting next to the fridge one of the Drifta Single Kitchen Drawers with table using four flush mounted tie down points. This would create an easy set up and removal as needed.
My question is do you think there will be any issues with this set up? The floor remains in place with the fridge slide all the way out just wondering if I had fridge slid out and then draw out is that asking too much of the two bolts that are into the back of the seats?
Any thoughts would be appreciated?
Thanks,
Andrew
Comment