Underbody protection

[Sinder Lurker Find all posts View Profile Close Sinder]

hi there.

I've seen a few bash plates that look like they go back as far as the sump. Are there any manufacturers that go back further than this? All the way to the transfer case? If not are there any aftermarket transfer case plates? 2000 diesel.

Also has anyone seen diff guards for the rear diff, or perhaps even trussed axles in the 90 series?

And while I'm at it.... Rear control arms?either strengthened mounts or replacement etc?

Thanks in advance.

Shannon

[scottkz Senior Member Find all posts View Profile Close scottkz]

Iv seen a current shape hilux with rear diff guard. .. Bassicly the same carrier would fit the prado carrier but theres brackets im not sure about

[glen_ep Addicted PP Member Find all posts View Profile Close glen_ep]

ASFIR offer a longer length guard and are very popular in Europe:
http://www.asfir.com/international/i...th=678_723_731

Rear diff guards / trussed - no never seen it on the 90. DIY only.

Rear arms mounts - if you mean the lower control arm mount which is weak if abused on rocks, then I definitely say re-enforce it, don't add one of those useless mount sliders. Mine is re-enforced and can be seen in my build up thread, but if done over again, I would do it a little differently. The tube shouldn't be welded under the chassis, a steel section should wrap around the chassis and be welded on either side.