Hi All,
I'm in the process of lifting my 90 series RV6, and am in need of some help from anyone who has done this.
I have removed all the bolts and body blocks down one side of my bus.
My main question is: did you replace the blocks, or add to them with new ones.
I'm just not sure if I should throw the original ones away and replace with one solid piece, or if I should make the blocks and sit them on top of the original ones.
Obviously one piece would be ideal, but the original ones seat down well into the bracket on the chassis, and are flat on top where they meet the body bracket.
Because they are flat on top I thought it may be better to put a 2 in block on top rather than replace the whole thing with a 3 in block.
Hope the above makes sense and looking forward to hearing some feedback.
Kind Regards,
Luke
I'm in the process of lifting my 90 series RV6, and am in need of some help from anyone who has done this.
I have removed all the bolts and body blocks down one side of my bus.
My main question is: did you replace the blocks, or add to them with new ones.
I'm just not sure if I should throw the original ones away and replace with one solid piece, or if I should make the blocks and sit them on top of the original ones.
Obviously one piece would be ideal, but the original ones seat down well into the bracket on the chassis, and are flat on top where they meet the body bracket.
Because they are flat on top I thought it may be better to put a 2 in block on top rather than replace the whole thing with a 3 in block.
Hope the above makes sense and looking forward to hearing some feedback.
Kind Regards,
Luke
Comment