150 GXL Diesel/ Auto

[Dusty74 Senior Member Find all posts View Profile Close Dusty74]

Don't recall any issues, and yes, Roadsafe, my bad

[matt150 Avid PP Poster! Find all posts View Profile Close matt150]

Truck is looking good Dusty.

[outback7 Banned Find all posts View Profile Close outback7]

Great looking rig Dusty......love the rear Kaymar bar.

[Dusty74 Senior Member Find all posts View Profile Close Dusty74]

Thanks guys, have to take a new shot, fitted up an ARB Alum roof rack just prior to Xmas. Little bit of wind noise empty, but you get that I suppose with most racks.

[outback7 Banned Find all posts View Profile Close outback7]

Welcome Dusty74! Huge amount of info on this site that will keep you busy and a never ending shopping list as well!

ARB was working on underbody protection but they have not released as yet have they?

I have an ARB underbody bash plates built for the 150.

[Dusty74 Senior Member Find all posts View Profile Close Dusty74]

Yep, I do too, that post was from quite awhile ago.

[SimpleSi Member Find all posts View Profile Close SimpleSi]

Another update, set of Wetseat seat covers for the second row seats showed up. Was pretty happy with the fronts so ordered these. The wife preferred the neoprene to canvas so they pretty much chose themselves!

Dusty, I like the look of those rear seat covers. Looking on the Wetseat website, I make it $330 for the rear seat covers?
My one concern with neoprene would be that it would be sweaty?

cheers

[Dusty74 Senior Member Find all posts View Profile Close Dusty74]

Yep, $330 plus delivery from memory. They are a little sweaty, up here in Cairns anyway, but not much more than standard seats. I'm pretty happy with them, take a lot of abuse from the kids and the fit for the rear seat is exceptional.

Cheers,
Dusty

[fido666 Banned Find all posts View Profile Close fido666]

Some recovery points went in as well, sourced from Road Runner Offroad, same as outback ideas I believe.

Hey Dusty where did you pass the nut on a wire thingys through the chassis? Had a look today when all the bash plates were off and couldn't figure it out. I have the TJM bar but mounting postion is pretty much the same.

[shodown Senior Member Find all posts View Profile Close shodown]

Also replaced the IPF Spottie switch with this number.



Jury's still out on this one, is a rather bulky switch and a bit bright at night, but it looked good on the web site!

Hi Dusty,

Did you have to file out the hole to fit the switch or direct fit?

Cheers,
Kevin