Announcement
Collapse
No announcement yet.
Search Result
Collapse
20 results in 0.0073 seconds.
Keywords
Members
Tags
-
I have finally solved my problem. I replaced injectors an everything have been fine since then. I havent updatet until now because I wanted to be sure....
-
-
well, it doesn't seem to be that easy. I have tried WD40 in E-VRV but it doesn't help. The outside temperature is now about 0 - 10 degrees Celsius, so...
Leave a comment:
-
Hello.
Sorry but I have not had time to troubleshoot the vehicle. The only thing I have tested is to replace MAF but it made no difference.
...
Leave a comment:
-
The filter one the blue valve snapped off after i started the diagnostic, so It was ok when the problems started.
When I took picture of...
Leave a comment:
-
-
Hi
The valve under the manifold, is connected between vacumpump and EGR valve. This one is OK when i check it with an ohm meter, and when...
Leave a comment:
-
Well, I found a manual, and is trying to check everyting step by step. I dont have any hand held tester, so i cant do everything, but there are steps...
Leave a comment:
-
Hi.
Its not chipped.
Here is the entire engine compartement.
I know we are talking about the same pipe....
Leave a comment:
-
I tried to figure out what you ment by swirl control, but it seems like my car doesnt have them.
My vacuum runs like this: fom the pump,...
Leave a comment:
-
I tried to clean this, but made no difference
I guess this one is the "main" EGR controller, but it is redusing the vacum....
Leave a comment:
-
This is where I'm connecting the gauge
This heat exchanger is open, and doesnt have any plate blocking it
...
Leave a comment:
-
Well, it wasn't... I tried to clean it with brake cleaner, but didn't make any difference.
I took a video of my boost gauge, and will post it when...
Leave a comment:
-
I just opened my MAF, and it seems clean from filter side, but it had a layer of dirt on the turbo side. Maybe that's my problem?
Leave a comment:
-
Thanx again.
I have checked both. The pipe that is connected to the cylinder head, and the actual valve. Both seems open and fine. And I can stick...
Leave a comment:
Leave a comment: