Sovereign bull bar fitting instructions

[amts Ninja Poster. Find all posts View Profile Close amts]

Looking at the instructions, it is a bit unclear to me. Once the bar is fitted, do I attach the guard to this metal undercover piece that fits into the corner of the bullbar?

Yes.
I'm missing those pieces on my bullbar. Are you able to trace it on a piece of paper? I might attempt to cut a plate to suit to fill the gap left by these 2 missing corner plates.

[sparksy Senior Member Find all posts View Profile Close sparksy]

Yes.
I'm missing those pieces on my bullbar. Are you able to trace it on a piece of paper? I might attempt to cut a plate to suit to fill the gap left by these 2 missing corner plates.

Are these the parts you are missing, I made the front fender retainers out of a old 120 bumper .

[amts Ninja Poster. Find all posts View Profile Close amts]

Are these the parts you are missing, I made the front fender retainers out of a old 120 bumper .

Yes, those were the bits that are missing. I was hoping to fashion something out of some plate I have. Looks like it probably won't be a completely flat piece like I'd hoped.

[sparksy Senior Member Find all posts View Profile Close sparksy]

Back when I fitted the bar up, those retainers weren't available as a spare part. This is photo of the ones I made , paint just starting to come off after more than 10years. Original phots are on post 24 on this thread. If you need I can measure up on the ones I made where the folds need to be made.