3.4L Pacemaker Extractors - impressions and install tips

[glen_ep Addicted PP Member Find all posts View Profile Close glen_ep]

Hopefully I used the right thing, I used this..

LOCTITE SILICONE SUPERFLEX RD HITEMP 59675 300ML

https://www.blackwoods.com.au/part/0...mp-59675-300ml

[rossy Junior Member Find all posts View Profile Close rossy]

fitted the extractors to my rig,seams to have made improved its midrange.all good so far.

[Nema Senior Member Find all posts View Profile Close Nema]

I have also fitted the pacemakers now and it make a noticeable difference in power throughout the rev range. I have just had the rear muffler and resonator changed by a local muffler place but not that happy with the result. It has a nice note now BUT it is a bit loud and not that happy with the workmanship (Welds are rough and they cut a bit of the fuel tank bracket to fit a large resonator in). Has anyone had the rear exhaust changed and is there anyone making a complete kit?

Cheers,

Dave

[oceanracer Moderated member Find all posts View Profile Close oceanracer]

Just to add to this thread, I didnt remove anything mine is a manual, I did remove all the studs and nuts and replaced them all, I did pre loosen and anti seize them, only used a deep 14mm socket no extensions and a 14 mm rachet spanner. Extractors and Y piece fitted in under 3 hrs and the rest of the exhaust in another hr and a half, had to Jack the rear up a few inchs to get the tail piece over the diff, all wheels were left on. Also used the Hi temp Locktite $40 a tube, my extractors had different flanges to Glens