Announcement
Collapse
No announcement yet.
Search Result
Collapse
22 results in 0.0065 seconds.
Keywords
Members
Tags
-
Replacing OEM Insulation
Comparing the "insulation" between my US-made Limited 4Runner and my "third world" Prado, there are some big differences in the quality....
-
I unplugged first just the KG2 and tested resistance between pale blue (PB) and black (Earth) while I operated the rocker. Then I unplugged the others...
-
This is what my wiring looks like, my jumper cable and all. ...
Leave a comment:
-
Re-read your message "monitor it with a multimeter and see if its state changes when all doors are shut, engine running and the switch is operated...Last edited by PradoFanLHD; 29-11-2020, 04:19 AM.
Leave a comment:
-
Did all you said but mine has THREE smaller plugs on top of the long one rather than four. The closest to the long one still does have a pale blue wire,...
Leave a comment:
-
12V on the Passenger Side of 2016 Prado 150
I was paging through some electrical diagrams and searching on the site but I cannot figure out what is the best way to tap into 12V on the passenger...
-
Thank you for all the info. The details are useful and I will look into it.
Sounds a bit daunting, but I think now you can run XPMode for...
Leave a comment:
-
I think I found some lengthy wiring PDFs here https://cardiagn.com/toyota-land-cru...ring-diagrams/
sifting...
Leave a comment:
-
Thanks driveway. It seems your project was strictly for unlocking? What did you find was the behavior of this pale blue wire in connector KG2-15 when...
Leave a comment:
-
Thanks GeeWhizz, though it is very small and not fully legibile for me. Where can I get/buy these diagrams?
Leave a comment:
-
Lock/Unlock Switch Elsewhere (e.g. either on center console box or in passenger side)
My vehicle is a 2016 model: KDJ150L-GKAEY, engine: 1KD-FTV.
Does anyone know how to put a rocker switch (similar to the OEM one on the driver's...
-
-
COWL SIDE TRIM BOARD RH strange fastener
Does anyone know why the abovementioned COWL SIDE TRIM BOARD RH (PNC 62111C part number 62111-60161-A1) is held in by a strange fastener called a "Clip...
-
Revisiting this, in my toolkit the right-angled jacking bar has two holes with only one threaded. The threaded, screw-bearing hole points toward the...
Leave a comment:
-
Old thread, but while I think the right-angled jacking bar screw seems missing there is an extension bar that does not carry any screw....
Leave a comment:
Leave a comment: