Announcement
Collapse
No announcement yet.
Search Result
Collapse
16 results in 0.0072 seconds.
Keywords
Members
Tags
-
Sound like you might have needed to perform a Zero Point Calibration for the steering angle and yaw rate sensors. This required after alignment and suspension...
-
Zero point calibration should be done after wheel alignement or when brakes or suspension changes are made. I use a scan tool to do mine.
...
Leave a comment:
-
Could it be over torqued lug nuts? It should only be 85ftlbs. Had my wheels balanced because of same problem you described but did not solve the steering...
Leave a comment:
-
Try doing a zero point calibration to reset yaw rate sensors and steering angle. Steering wheel has to be straight,tyre pressure even, car level and no...
Leave a comment:
-
Try not to touch the headlight bulb with bare hands. Read link below.
https://www.gmtruckclub.com/forum/th...g-out.1007586/Last edited by Milkmanstan; 14-07-2018, 09:18 PM.
Leave a comment:
-
Hi Phs,
I am assuming that you have a extended airbag matching the lift in the front.
Both your sensors should read 0mm at normal...
Leave a comment:
-
Look up your owner's manual to confirm. It should state the preferred and acceptable range of oil viscosity requirement for your vehicle.
20w- 40,...
Leave a comment:
-
Hi Phs,
Sensor @ high mode - 4.4 - 4.6V
Sensor @ normal mode- 2.3- 2.6 V
Sensor @ Low mode - 0.4 - 0.6V
...
Leave a comment:
-
PHS,
You will need a scan tool to see the output of the sensor. It seems that if you move one sensor the other sensor reading changes and does not...
Leave a comment:
-
Hi Hutcho,
I've had the same problem with stock suspension, send it in to Toyota but they did a worse job than before. I thought I had night...Last edited by Milkmanstan; 29-07-2016, 09:31 PM.
Leave a comment:
-
Hope you solve your brake problems. $1800 for a master cylinder? Maybe they added an extra zero by mistake either that or I'll really out of touch with...
Leave a comment:
-
Hi,
I had similar problem with my brakes not biting and "long brake pedal" after I had my tyres replaced and aligned at Bob Jane. Lug...Last edited by Milkmanstan; 13-07-2016, 09:18 PM.
Leave a comment:
-
Had my rear cargo door damper changed under warranty as there was some rust. Check yours. No other fault found.
Leave a comment:
-
Hi Rickoshea,
Check to see if the car jack is firmly extended so that it braces itself in it's mount and check if is the tools in the back...
Leave a comment:
-
It definitely works on H4, should work on low 4, don't see a reason why would Toyota disable it on low 4.
You feel the car wallow abit...
Leave a comment:
Leave a comment: