Announcement
Collapse
No announcement yet.
Search Result
Collapse
14 results in 0.0056 seconds.
Keywords
Members
Tags
-
For about $25 of electronic components and by following the instructions in this link https://www.pradopoint.com.au/forum/...i-tdcl-vs-mobd you can hook...
- 1 like
-
Excellent information thanks.
I just used a Fuel Miser coil as it was available immediately off the shelf. However, I would really like to...
- 1 like
Leave a comment:
-
Either severe over-fueling running...
- 1 like
Leave a comment:
-
The plenum chambers must be removed to service the fuel...
Leave a comment:
-
Just developed a misfire with no error codes and limped home. Initially was an occasional miss when lugging at low revs but then happened throughout the...
- 1 like
Leave a comment:
-
I used the original canister mount bracket welded to the battery tray. So the canister simply unclips from the bracket and lifts out of the way to access...
Leave a comment:
-
I welded the existing canister bracket to the side of a steel battery tray that I installed in the LH rear space.
The canister is now crowded...Last edited by 96VZJ95; 15-11-2021, 07:28 PM.
Leave a comment:
-
Attached is a fabricated throttle cable bracket for 1996 models to use later throttle bodies....
- 1 like
Leave a comment:
-
OK so the butterfly shaft had a few mm of up/down play when held open which is the air leak causing high idle.
I swapped for the 2001 body which...
- 1 like
Leave a comment:
-
The DIY cable and free software worked first time on my laptop. I can see 14 parameters live updated.
The temperature sensor works OK and...Last edited by 96VZJ95; 09-11-2021, 03:45 PM.
- 2 likes
Leave a comment:
-
Great price. Have you tried it in mud yet?
I have had a rear elocker for the last several years. I wired it with an extra switch in series...
Leave a comment:
-
See the post regarding Prado OBD1 here: https://www.pradopoint.com.au/forum/...i-tdcl-vs-mobd
A Toyota OBD1 to OBD2 cable will not enable...
- 1 like
Leave a comment:
-
5VZ-FE throttle bodies
So I have high idle problems with my 1996 V6.
There is a bit of side play in the butterfly shaft and the dashpot/stop linkage seems to resist the...
- 1 like
-
Fabricating steel heater pipes
Well the steel heater pipe on my 1996 VZJ95 has suffered bad electrolysis and is proving difficult to source new. Consequently I made one.
The original...1 Photo
Leave a comment: